IRControl Support Forum

Hi Meziane

I analyzed it now with an internal IRBlaster and found the problem. Unfortnately it is the same problem like in Send Test Dialog: Extra parameters are not transfered to the logic building the infrared sequence. So we made a quick of the App for you. I will receive the link how to download in a private mail.

best regards,
Urs

Hi Urs,

Ok, nice!

Best regards

Hi Urs,

As said by PM it's ok now... Very good job... Thanks a lot

Say me how you want to progress now before I send a mail to Velleman team to close (if you agree I'll point to your Apps to give information to the community about the new compatibility with this robot).

Best regards

Hi Meziane

Nice - we can control roboters

I think we will enhance the protocol interface, so we can transmit the full range from 1 to 250 for speed configuration. I think we also make this parametrizable for setting the speed via a wheel control. Finaly we can make a downloadable ready to use configuration (ipac). Maybe we could release this till the end of the month.

Of course you can tell Vellemann and to their community about our project.

You can also use following other infrared transmitters for sending this ir codes:
- Global Caché iTach
- Broadlink
- IRTrans
- IrDroid

best regards,
Urs

Hi Urs,

This afternoon I worked on it and I thought that it would be nice to be able to adjust the speed with a wheel... thus I fully agree with your idea !

To have this by the end of the month would be simply fantastic!

Once this will be ready, I will inform Velleman team and the community.

Of course if you'd need tester... I'm fully ok to help!

Best regards

Hi Meziane

I sent you a link to download the prerelease for the Allbot integration together with an ipac for install a control page. Would be nice, if you can have a look at it.

best regards,
Urs